This only 1.75g small automotive connector is developed by a USA automotive Tier1 manufacturer, applied in automotive airbag electricity controlling system, we design and make the connector injection mold according to customer’s product drawing.

Mold shown:Requiring sliders from three directions, 4pcs hot runners, direct needle valves gates, 4 sensors.

Nameplate:

Machining capability:

Customer introduction:

A leading global Tier 1 automotive supplier that serves all of the world’s major automakers with content on more than 400 vehicle nameplates worldwide as well as one of the world's largest suppliers of automotive seating and E-Systems.It provides complete seating systems and components, as well as both traditional and high voltage/high power electronic products and E-Systems and components.

Package:

http://www.diviz-plasticinjection.com/